Dell S4810 Reference Manual page 163

Parameters
ipv4-address
ipv6-address
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.1.1.0
Version 7.5.1.0
E-Series
Usage You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only
Information one of each. Each time this command is issued, it replaces the previously
configured address of the same family, IPv4 or IPv6. The no virtual-ip
command takes an address/prefix-length argument, so that the desired address
only is removed. If you enter the no virtual-ip command without any specified
address, then both IPv4 and IPv6 virtual addresses are removed.
Related ip address
Commands
Control and Monitoring
Enter the IP address of the active management interface in a
dotted decimal format (A.B.C.D.).
Enter an IPv6 address of the active management interface, in
the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Introduced on the S6000.
Introduced on the Z9000
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Original command.
— assigns a primary and secondary IP address to the interface.
163