Show Port Description; Show Port Status - NETGEAR ProSafe GSM7228PS Cli Manual

show port description

This command displays the port description for every port.
Format
show port description <unit/slot/port>
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes
Description Shows the port description configured via the "description" command

show port status

This command displays the Protocol-Based VLAN information for either the entire system, or for
the indicated group.
Format
show port status {<unit/slot/port> | all}
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Media Type "Copper" or "Fiber" for combo port.
STP Mode Indicate the spanning tree mode of the port.
Physical Mode Either "Auto" or fixed speed and duplex mode.
Physical Status The actual speed and duplex mode.
Link Status Whether the link is Up or Down.
Loop Status Whether the port is in loop state or not.
Partner Flow Whether the remote side is using flow control or not.
Control
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-9