Show Port Advertise; Speed All - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches
no shutdown all
This command enables all ports.
Format
no shutdown all
Mode Global Config
speed
This command sets the speed and duplex setting for the interface.
Format
speed [auto] [{<100 | 10 | 10G> {half-duplex | full-duplex>}}]
Mode Interface Config

speed all

This command sets the speed and duplex setting for all interfaces.
Format
speed all [auto] [{<100 | 10> {<half-duplex | full-duplex>}}]
Mode Global Config

show port advertise

Use this command to display the local administrative link advertisement configuration, local
operational link advertisement, and the link partner advertisement for an interface. It also
displays priority Resolution for speed and duplex as per 802.3 Annex 28B.3. It displays the
autonegotiation state, Phy Master/Slave Clock configuration, and Link state of the port.
If the link is down, the Clock is displayed as No Link, and a dash is displayed against the Oper Peer
advertisement, and Priority Resolution. If autonegotiation is disabled, the admin Local Link
advertisement, operational local link advertisement, operational peer advertisement, and Priority
resolution fields are not displayed.
If this command is executed without the optional slot/port parameter, it displays the
autonegotiation state and operational Local link advertisement for all the ports. Operational link
advertisement will display speed only if it is supported by both local as well as link partner. If
autonegotiation is disabled, operational local link advertisement is not displayed.
Format
show port advertise [slot/port]
Mode Privileged EXEC
Example: The following commands show the command output with and without the optional
parameter:
(switch)#show port advertise 0/1
Port: 0/1
Type: Gigabit - Level
Switching Commands
25