Option 81 Commands; Radius Server Attribute 4; No Radius Server Attribute 4; Authorization Network Radius - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Pending
Requests
Timeouts
Unknown Types
Packets Dropped
11.3 802.1x Option 81 Commands
This section describes the commands you use to configure the 7300S Series Stackable
Switch to use 802.1x Option 81.

11.3.1 radius server attribute 4

This command is used to set the NAS-IP address for the RADIUS server.
Format
Mode

11.3.2 no radius server attribute 4

This command is used to reset the NAS-IP address for the RADIUS server.
Format
Mode

11.3.3 authorization network radius

This command is used to enable the switch to accept vlan assignment by the radius server.
Format
Mode
Port-Based Access and Authentication Commands
The number of RADIUS Access-Request packets destined
for this server that have not yet timed out or received a
response.
The number of authentication timeouts to this server.
The number of RADIUS packets of unknown types, which
were received from this server on the authentication port.
The number of RADIUS packets received from this server on
the authentication port and dropped for some other reason.
802.1x port security.
radius server attribute 4 <ip-address>
Global Config
no radius server attribute 4
Global Config
authorization network radius
Global Config
v4.1, October 2008
11-21