Data Processing Unit (Dpu) Kit - Dell PowerEdge R6615 Installation And Service Manual

Figure 145. Installing the BOSS-N1 module blank
To install the BOSS-N1 module:
1. Install the BOSS-N1 module . To install the BOSS-N1 , see
2. Install the M.2 SSD. To install the M.2 SSD, see
NOTE: Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS-N1 controller card module.
To remove the BOSS-N1 module:
1. Power off the system.
2. Remove the M.2 SSD. To remove the M.2 SSD, see
3. Remove the BOSS-N1 module. To remove the BOSS-N1 controller card module, see
4. Install the BOSS-N1 module blank.
NOTE: Removal of the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when removing the BOSS-N1 module.
NOTE: Disconnect the BOSS signal cable and the BOSS power cable before lifting the module from the system.

Data Processing Unit (DPU) kit

The channel or vendor DPU kit contains one 25G Network card. For installation procedure of Network card, see
expansion card into the expansion card riser
For more information about the supported channel DPU slots, See
installing the BOSS-N1
installing M.2 SSD.
removing the M.2
section.
Expansion card installation Guidelines
module.
SSD.
removing the BOSS-N1 module.
Installing an
section.
Upgrade Kits 177