Cylinder Head Removal - Honda Accord 2008 Manual

07/11/02 09:25:03 61TA0000_060_0078
Cylinder Head
Cylinder Head Cover Installation
(cont'd)
8. Install the two bolts (A) securing the evaporative
emission (EVAP) canister purge valve bracket.
＊０５
D
9. Install the power steering (P/S) hose bracket (B), the
breather hose (C), and the dipstick (D).
10. Install the four ignition coils (see page 4-21).
11. Install the intake manifold cover.
＊０６
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
33 lbf·ft)
12. Install the strut brace (if equipped) (see page
20-287).
6-78 6-78
B
A
C

Cylinder Head Removal

NOTE:
• Use fender covers to avoid damaging painted
surfaces.
• To avoid damage, unplug the wiring connectors
carefully while holding the connector portion.
• To avoid damaging the cylinder head, wait until the
engine coolant temperature drops below 100 °F
(38 °C) before loosening the cylinder head bolts.
• Mark all wiring and hoses to avoid misconnection.
Also, be sure that they do not contact other wiring or
hoses, or interfere with other parts.
1. Remove the strut brace (if equipped) (see page
20-287).
2. Relieve the fuel pressure (see page 11-358).
3. Drain the engine coolant (see page 10-6).
4. Remove the drive belt (see page 4-31).
5. Remove the intake manifold (see page 9-3).
6. Remove the catalytic converter (see page 11-393).
7. Remove the evaporative emission (EVAP) canister
hose (A).
ＴＡ０８ＡＥＪＡ１４６００００００００ＫＡＡＴ００
A
＊０１