Honda Accord 2008 Manual page 195

07/11/02 09:25:00 61TA0000_060_0072
Cylinder Head
Auto-tensioner Removal and Installation (cont'd)
Installation
1. Install the auto-tensioner.
NOTE: Check the auto-tensioner cam position. If the
position are not aligned, set the first cam to the first
edge of the rack.
＊０５
2. Remove the pin or lock pin (P/N 14511-PNA-003)
from the auto-tensioner.
＊０６
3. Remove the old liquid gasket from the chain case
cover mating surfaces, the bolts, and the bolt holes.
4. Clean and dry the chain case cover mating surfaces.
6-72
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
5. Apply liquid gasket, P/N 08717-0004, 08718-0001,
08718-0003, or 08718-0009, evenly to the chain
case mating surface of the chain case cover. Install
the component within 5 minutes of applying the
liquid gasket.
NOTE:
• If you apply liquid gasket P/N 08718-0012, the
component must be installed within 4 minutes.
• If too much time has passed after applying the
liquid gasket, remove the old liquid gasket and
residue, then reapply new liquid gasket.
6. Install the chain case cover.
NOTE:
• Wait at least 30 minutes before filling the engine
with oil.
• Do not run the engine for at least 3 hours after
installing the chain case cover.
Apply liquid gasket
along the broken line.
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
＊０７
＊０８