Show Control-Traffic Protocol - Dell Z9500 Reference Manual

class-map cpu-qos
qos-policy-input cpu-qos
policy-map-input cpu-qos

show control-traffic protocol

Display per-protocol counters of rate-limited control-plane traffic.
Z9500
Syntax
show contol—traffic protocol [cp—switch | linecard slot-id
portset port-pipe] counters
Parameters
cp-switch
linecard slot-id
portset port-
pipe
Defaults None
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
Usage
There are three line cards (0-2) with fixed ports on the Z9500. Line card 0 uses
Information
three sets of ports (port pipes): 0 to 2; line cards 1 and 2 use four sets of ports: 0 to
3.
In the show control-traffic protocol output, RxBytes displays the number
of bytes of control-plane traffic received on which protocol-based rate limiting is
applied. TxBytes displays the number of bytes transmitted to a control-plane CPU
after protocol-based rate limiting is applied. Drops displays the number of bytes of
control-plane traffic that have been dropped as a result of protocol-based rate
limiting.
566
— creates a QoS class map for CoPP.
— creates a QoS input-policy map for CoPP.
— creates an input-policy map for CoPP.
Enter the keyword cp-switch to display counters for rate-
limited traffic on the central switch (aggregated CoPP).
Enter the slot ID and port pipe to display counters for rate-
limited traffic on a specified Z9500 line card and port set.
The range of Z9500 slot IDs is from 0 to 2. The range of
port-pipe numbers is: 0 to 2 on line card 0; 0 to 3 on line
cards 1 and 2.
Description
Introduced on the Z9500.
Control Plane Policing (CoPP)