Backup-Pe-Group - Dell PowerConnect J-EX4200-24T Software Manual

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Required Privilege
Level
Related
Documentation

backup-pe-group

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
1488
NOTE: When you specify the same AS number in more than one routing
instance on the local routing device, you must configure the same number
of loops for the AS number in each instance. For example, if you configure a
value of 3 for the
same AS number as that of the master instance, you must also configure a
value of 3 loops for the AS number in the master instance.
Use the
independent-domain
only on a subset of routing instances.
The remaining statement is explained separately.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
independent-domain
Configuring AS Numbers for BGP
backup-pe-group group-name {
backups [ addresses ];
local-address address;
}
[edit logical-systems logical-system-name routing-instances routing-instance-name
routing-options multicast],
[edit logical-systems logical-system-name routing-options multicast],
[edit routing-instances routing-instance-name routing-options multicast],
[edit routing-options multicast]
Statement introduced before Junos OS Release 10.2 for J-EX Series switches.
Configure a backup provider edge (PE) group for ingress PE redundancy when
point-to-multipoint label-switched paths (LSPs) are used for multicast distribution.
—Name of the group for PE backups.
group-name
The remaining statements are explained separately.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Configuring Ingress PE Redundancy
statement in a VRF routing instance that uses the
loops
option if the
loops
statement must be enabled