Installing The Front Door And Air Intake Frame - Cisco Nexus 7018 Manual

Hide thumbs Also See for Nexus 7018:

Installing the Front Door and Air Intake Frame

Figure 12: Fastening the Top Hood to the Chassis and Cable Management Assemblies

Four M4x8 pan-head screws that fasten the top

hood to the chassis.

Step 7

Use four M4x8 pan-head screws to loosely fasten the top hood to each of the two upper cable management assemblies

as shown in

Figure 11: Positioning the Top Hood with the Upper Cable Management Assemblies and the Switch Chassis,

on page

21.

Step 8

Tighten each of the four screws that fasten the top hood to the chassis to 11 to 15 in-lb (1.2 to 1.7 N·m).

Step 9

Tighten each of the four screws that fasten the top hood to the cable management assemblies to 11 to 15 in-lb (1.2 to

1.7 N·m).

Step 10

Tighten each of the 18 screws that fasten the upper and lower cable management assemblies to the rack-mount brackets

to 11 to 15 in-lb (1.2 to 1.7 N·m).

Installing the Front Door and Air Intake Frame

If you need to install the optional double-hinged door and air intake frame, you must install them after installing

the cable management frame on the chassis.

Note

To install the front door and air intake frame to the Cisco Nexus 7018 cable management system, follow these

steps:

Installing a Cisco Nexus 7018 Chassis

For the double-hinged door to easily open or close in either direction, make sure that the chassis is level. If

necessary, remove the chassis from the rack and adjust the bottom-support rails so that the chassis is level.

Also, make sure that the cable management frame is aligned to the vertical sides of the chassis and that the

cable management hood is level when you install those components.

Four M4x8 pan-head screws that fasten the top hood to the left

and right cable management assemblies.

Installing a Cisco Nexus 7018 Chassis

Table of Contents