Installing And Removing Components; Table Of Contents - Cisco UCS 5108 Installation Manual

Installing and Removing Components

This chapter describes how to remove components from the chassis and how to install components into the
chassis. This section contains the following section:
•
•
•
•
•
•
•
•
Components
The following figure shows an empty Cisco UCS 5108 server chassis and identifies the front, back, and module
slots.
Note
Whenever you remove a module from the chassis for an extended period of time, always replace the module
with the appropriate blank panel. Failing to do so can result in heating and EMI issues. Blank panels can be
ordered from Cisco Systems.
Components, on page 59
Installing and Removing a Blade Server, on page 61
Installing and Removing Power Supplies, on page 63
Installing and Removing a Power Distribution Unit (PDU), on page 66
Replacing an I/O Module (or UCS 6324 Fabric Interconnect For UCS Mini), on page 68
Migration to UCS 6400 Series Fabric Interconnects and UCS 2408 IOMs, on page 69
Migrating to UCS 6300 Series Fabric Interconnects and the UCS 2304 IOM, on page 70
Installing and Removing a Fan Module, on page 72
3
C H A P T E R
Cisco UCS 5108 Server Chassis Installation Guide
59