Removing And Replacing The Chassis Cover; Removing The Chassis Cover - Cisco ASA5500-HW - Hardware Accessory Kit Network Device Hardware Installation Manual

Maintenance and Upgrade Procedures
This chapter includes the following sections:
•
•
•
•
•

Removing and Replacing the Chassis Cover

This section describes how to remove and replace the chassis cover. This section includes the following
topics:
•
•

Removing the Chassis Cover

To remove the chassis cover, perform the following steps:
Step 1 Read the Regulatory Compliance and Safety Information for the Cisco ASA 5500-X Series document.
Step 2 Power off the chassis.
Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord.
Warning
Statement 1
Turn the thumbscrew on the front of the chassis. See
Step 3
the screw is too tight.
Note
Removing and Replacing the Chassis Cover, page 4-1
Installing an I/O Card in the Cisco ASA 5512-X, 5515-X, and 5525-X Chassis, page 4-3
Installing an I/O Card in the Cisco ASA 5545-X and 5555-X Chassis, page 4-7
Removing and Installing the Power Supply, page 4-11
Installing and Removing the SFP Modules, page 4-13
Removing the Chassis Cover, page 4-1
Replacing the Chassis Cover, page
Removing the chassis cover does not affect Cisco warranty. Upgrading the ASA does not require
any special tools and does not create any radio frequency leaks.
C H A P T E R
4-2s
Figure 4-1. You may need to use a screwdriver if
Cisco ASA 5500-X Series Hardware Installation Guide
4
4-1