Part And Tool Requirements; General Safety Precautions And Maintenance Guidelines - Cisco 6160 Installation And Replacement Notes

Part and Tool Requirements

Specifications
Table 2
Table 2
Specification
Dimensions
Weight
Power consumption
Minimum software and
network management
requirements
1. CDM = Cisco DSL Manager
Part and Tool Requirements
Table 3
Table 3
Check

General Safety Precautions and Maintenance Guidelines

This section describes the following areas:
•
•
•
Specifications
4
lists the specifications for the PEM.
PEM Specifications
Description
Height: 8.82 in. (22.4 cm)
Depth: 9.27 in. (23.55 cm)
Width: 2.45 in. (6.223 cm)
6 lb (2.72 kg)
60W
Cisco IOS—Release 12.0(5)DA
CDM
lists the tools and equipment that you need to install and remove a PEM.
Tool and Equipment Requirements Checklist
Tools and Equipment
PEM.
Equipment necessary for ESD protection—You need this equipment whenever you handle
Cisco chassis, modules, and cards.
3/8-inch Phillips-head screwdriver.
Cisco IOS or CDM
See Table 2
Note
General Safety Precautions, page 5
General Maintenance Guidelines, page 9
Preventing Electrostatic Discharge Damage, page 9
1
—Release 3.2 (optional)
for minimum software and network management release requirements.
OL-2181-01