Attach Fiber Management Bracket; Adjust Fiber Management Bracket Of The 1.2T Line Card - Cisco NCS 1004 Hardware Installation Manual

Attach Fiber Management Bracket

Figure 45: Spring-loaded Lever in Released Condition
1 Sping-loaded lever
Attach Fiber Management Bracket
This task has details about attaching a fiber management bracket to a line card or filler card.
Step 1 Fix the fiber management bracket to the card (line card or filler card, as the case may be).
Step 2
Using a Torx screwdriver, tighten the two M3 T15 Torx screws of the fiber management bracket to a torque value of
0.65 N-m.
The procedure to adjust the length of the fiber management bracket is discussed in the subsequent section.

Adjust Fiber Management Bracket of the 1.2T Line Card

This task has details about how to adjust the length of the fiber management bracket.
Note
We recommend that you maintain the fiber management bracket in the shorter position for ETSI racks, to
maintain 600 mm footprint. We also recommend that you adjust the bracket length before the installation.
Step 1 Push the plunger pins downwards on both the sides of the bracket, to disengage the horizontal bar.
Hardware Installation Guide for Cisco NCS 1004
48
Install Cisco NCS 1004 Modules