Seq Arp (For Extended Mac Acls) - Dell S6000 Reference Manual

Command
Version 9.4(0.0)
History
Version 9.3(0.0)
Usage
When the configured maximum threshold is exceeded, generation of logs is
Information
stopped. When the interval at which ACL logs are configured to be recorded
expires, the subsequent, fresh interval timer is started and the packet count for that
new interval commences from zero. If ACL logging was stopped previously
because the configured threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-
enabled after the logging interval period elapses. ACL logging is supported for
standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure
ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable
logging for ACLs that are associated with egress interfaces.
You can activate flow-based monitoring for a monitoring session by entering the
flow-based enable command in the Monitor Session mode. When you enable
this capability, traffic with particular flows that are traversing through the ingress
and egress interfaces are examined and, appropriate ACLs can be applied in both
the ingress and egress direction. Flow-based monitoring conserves bandwidth by
monitoring only specified traffic instead all traffic on the interface. This feature is
particularly useful when looking for malicious traffic. It is available for Layer 2 and
Layer 3 ingress and egress traffic. You may specify traffic using standard or
extended access-lists. This mechanism copies all incoming or outgoing packets on
one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).
Related
ip access-list extended
Commands
permit
permit udp

seq arp (for Extended MAC ACLs)

Configure an egress filter with a sequence number that filters ARP packets meeting this criteria. This
command is supported only on 12-port GE line cards with SFP optics. For specifications, refer to your line
card documentation.
NOTE: Only the options that have been newly introduced in Release 9.3(0.0) and Release 9.4(0.0)
are described here. For a complete description on all of the keywords and variables that are
available with this command, refer the topic of this command discussed earlier in this guide.
Syntax
seq sequence-number {deny | permit} arp {destination-mac-
address mac-address-mask | any} vlan vlan-id {ip-address | any
Access Control Lists (ACL)
Added support for flow-based monitoring on the S4810,
S4820T, S6000, and Z9000 platforms.
Added support for logging of ACLs on the S4810, S4820T,
and Z9000 platforms.
— creates an extended ACL.
— assigns a permit filter for IP packets.
— assigns a permit filter for UDP packets.
283