Configuring The Framing Format And Line Coding Format; Creating A Ts Set; Set A Physical State Change Suppression Interval On A T1 Interface - HP FlexNetwork MSR Series Configuration Manual

Step
1. Enter system view.
2. Enter T1 interface view.
3. Configure a TDM clock
source for the T1 interface.

Configuring the framing format and line coding format

Step
1. Enter system view.
2. Enter T1 interface view.
3. Configure the framing
format.
4. Configure the line coding
format.
For more information about the frame-format and code commands, see HPE FlexNetwork MSR
Router Series Comware 5 Interface Command Reference.

Creating a TS set

Step
1. Enter system view.
2. Enter T1 interface view.
3. Create a TS set
according to the selected
signaling mode.
4. Enter CAS view.
5. Configure a T1 trunk
routing mode.
Set a physical state change suppression interval on a T1
interface
Step
1. Enter system view.
2. Enter T1 interface view.
Command
system-view
controller t1 slot-number
tdm-clock { internal | line
[ primary ] }
Command
system-view
controller t1 slot-number
frame-format { esf | sf }
code { ami | b8zs }
Command
system-view
controller t1 slot-number
timeslot-set ts-set-number
timeslot-list timeslots-list signal
{ e&m-delay | e&m-immediate |
e&m-wink | fxo-ground | fxo-loop |
fxs-ground | fxs-loop | r2 }
cas ts-set-number
select-mode [ max | maxpoll | min |
minpoll ]
Command
system-view
controller T1 slot-number
66
Remarks
N/A
N/A
Optional.
By default, the internal clock is
used as the TDM clock source.
Remarks
N/A
N/A
Optional.
The default is ESF.
Optional.
The default is B8ZS.
Remarks
N/A
N/A
By default, no TS set is
configured.
N/A
Optional.
By default, the timeslot with the
lowest number is selected from all
available timeslots for routing.
Remarks
N/A
N/A