Distance Measurement; Scan Mode - Leica PINMASTER II PRO Instructions Manual

98

DISTANCE MEASUREMENT

To measure the distance to an object, it must be
perfectly targeted. To do this, activate the target mark
by pressing the main button
button is released, the target mark continues to be
displayed for approx. 4 seconds. If the button is kept
pressed down, the target mark remains lit. While the
target mark is lit, aim at the object and press the main
button a second time; the distance is then measured
and displayed. The target mark goes out briefly during
the measurement. A new measurement can be made
at any time, as long as the target mark is lit, by
pressing the main button once again. If the object is
less than 10m away, out of range, or does not provide
enough reflection, then
- - -
2
once. When the main
appears in the display.
When the display goes out, the Leica Pinmaster II Pro
switches off automatically.

SCAN MODE

The Leica Pinmaster II Pro can also be used for
measurements in continuous mode: If the main button
2
is held down the 2nd time it is pressed, the unit
switches to scan mode after approx. 0.5 seconds and
then performs measurements permanently. This is
indicated by alternating displays: A new measured
value is displayed every approx. 0.5 seconds.
Scan mode is particularly practical when measuring the
distance to flagpoles and other small objects.
Note:
The power consumption during scan mode is higher
than with individual measurements due to the
continuous measurement.
EN
25