SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 1667

Installation
1. Thoroughly clean the adhesive primer applying area on
windshield.
1) Keep the width of 15 mm from the windshield end to
cleaned area.
2) The gauze that has been used over 20 times should
be disposed.
3) Fully dampen the gauze with a solution (isopropyl
alcohol).
4) Do not contact your fingers to the cleaned glass
surface.
5) Apply the adhesive primer around the fully dried glass.
6) Make sure to thoroughly remove the foreign materials
such as oil and dirt from the adhesive primer applying
area.
2. Install new weatherstrip around the windshield.
Notice
The windshield should be installed within 5 minutes
after applied the glass adhesive.
3. Apply the adhesive around the windshield.
Notice
• If the adhesive bead is not constant and the applied
volume and height is not even, it may cause the
waterleaks.
• Be careful not to contact the weatherstrip and glass
dam when applying the adhesive with a nozzle.
EXTERIOR
REXTON SM - 2004.4
Plastic container
Gauze
Adhesive applying
device
B
A
Windshield
11C-53
Turn table
Solvent
(Isopropyl alcohol)
Y220_11C129
A
Windshield
Section A-A
Y220_11C130
Section A-A
Section B-B
Y220_11C131
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN