SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 1668

11C-54
Priming container
B
Upper cowl panel
b
Windshield corner
a
Spacer
A
location
Spacer
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
4. Clean the windshield installation flange.
A
Windshield
installation flange
Y220_11C132
5. Insert the windshield spacer.
Y220_11C133
6. Install the windshield.
Note
If a clearance exists between weatherstrip and body
around the glass corners (b), adjust it by using the
spacers (A).
B
Windshield
corner
Y220_11C134
• The gauze that has been used over 20 times should
be disposed.
• Fully dampen the gauze with a solution (isopropyl
alcohol).
• Make sure to thoroughly remove the foreign materials
such as oil and dirt from the adhesive primer applying
area.
• Apply the adhesive primer around the fully dried glass.
• Usable period after applied: 3 minutes to 8 hours
(reapply after 8 hours)
• When contaminated by the primer: Clean the
contaminants using a cloth with a cleaning solution
such as the mixed agent of ethyl alcohol and ethyl
acetate (50:50).
• Dispose the out of available period primer (90 days).
• Be careful not to flow down the primer. It may
contaminate the vehicle body.
• Insert it until it sounds "click" on the step.
• No gap is accepted.
EXTERIOR
REXTON SM - 2004.4