Fore/Aft Adjustment - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

Fore/Aft Adjustment

1. The door must be properly aligned.
2. Close the door until the lock fork contacts the striker.
3. Stand next to the door opening and move the door slowly
in and out, just touching the striker each time.
4. The alignment of the lock fork and the striker can be easily
seen. The lock fork should be perpendicular to and fall
near the middle of the striker between the B-pillar and the
end of the striker.
5. If a fore or aft adjustment is required, use the following
steps:
1) Remove the striker screws.
2) Remove the spacer in order to move the striker toward
the front of the vehicle.
3) Add a 2 mm (0.8 inch) spacer in order to move the
striker toward the front of the vehicle.
4) Install the striker screws.
6. Perform the up/down or the in/out adjustment. Refer to
"up/down or in/out Adjustment" in this section.
EXTERIOR
REXTON SM - 2004.4
11C-35
Y220_11C074
Y220_11C075
Y220_11C076
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN