Bgp Router-Id - Dell Z9500 Reference Manual

Examples
Dell(conf-router_bgp)#no bgp regex-eval-optz-disable
Dell(conf-router_bgp)#do show ip protocols
Routing Protocol is "ospf 22222"
Routing Protocol is "bgp 1"
Regular expression evaluation optimization enabled
Dell(conf-router_bgp)#
Related show ip protocols
Commands on the E-Series.

bgp router-id

Assign a user-given ID to a BGP router.
Z9500
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback
interfaces are configured, the highest IP address of a physical interface on the
router.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
362
Router ID is 2.2.2.2
Area
51
Cluster Id is set to 10.10.10.0
Router Id is set to 10.10.10.0
Fast-external-fallover enabled
Capable of ROUTE_REFRESH
For Address Family IPv4 Unicast
BGP table version is 0, main routing table version 0
Distance: external 20 internal 200 local 200
— views information on all routing protocols enabled and active
Enter an IP address in dotted decimal format to reset only
that BGP neighbor.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Routing for Networks
10.10.10.0/00
Border Gateway Protocol