Clearing And Resetting Bgp4+ Routes In The Ipv6 Route; Table; Clearing Traffic Counters For All Bgp4+ Neighbors; Displaying Bgp4+ Information - Dell PowerConnect B-RX Configuration Manual

45

Displaying BGP4+ information

Clearing BGP4+ neighbor route flap dampening statistics
The switch allows you to clear all route flap dampening statistics for a specified BGP4+ neighbor.
NOTE
Clearing the dampening statistics for a neighbor does not change the dampening status of a route.
To clear all of the route flap dampening statistics for a neighbor, enter a command such as the
following at the Privileged EXEC level or any of the Config levels of the CLI.
BigIron RX# clear ipv6 bgp neighbor 2000:e0ff:47::1 flap-statistics
Syntax: clear ipv6 bgp neighbor <ipv6-address> flap-statistics
The <ipv6-address> parameter specifies a neighbor by its IPv6 address. You must specify this
address in hexadecimal using 16-bit values between colons as documented in RFC 2373.
Specify the flap-statistics keyword to clear route flap dampening statistics for the specified
neighbor.

Clearing and resetting BGP4+ routes in the IPv6 route

table

You can clear all BGP4+ routes or only those routes associated with a particular IPv6 prefix from
the IPv6 route table and reset the routes. When cleared, the BGP4+ routes are removed from the
IPv6 main route table and then restored again.
For example, to clear all BGP4+ routes and reset them, enter the following command at the
Privileged EXEC level or any of the Config levels of the CLI.
BigIron RX# clear ipv6 bgp routes
Syntax: clear ip bgp routes [<ipv6-prefix>/<prefix-length>]
The <ipv6-prefix>/<prefix-length> parameter clears routes associated with a particular IPv6 prefix.
You must specify the <ipv6-prefix> parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373. You must specify the <prefix-length> parameter as a decimal value. A
slash mark (/) must follow the <ipv6-prefix> parameter and precede the <prefix-length>
parameter.

Clearing traffic counters for all BGP4+ neighbors

To clear the message counters (reset them to 0) for all BGP4+ neighbors, enter the following
command.
BigIron RX(config)# clear ipv6 bgp traffic
Syntax: clear ipv6 bgp traffic
Displaying BGP4+ information
You can display the following BGP4+ information:
•
1122
BGP4+ route table.
BigIron RX Series Configuration Guide
53-1001986-01