Speed (For 10/100/1000 Interfaces) - Dell S4810 Reference Manual

speed (for 10/100/1000 interfaces)

Set the speed for 10/100/1000 Base-T Ethernet interfaces. Set both sides of a link to the same speed
(10/100/1000) or to auto or the link may not come up.
S4810
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed {10 | 100 | 1000}
command.
Parameters
10
100
1000
auto
Defaults auto
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
798
Enter the keyword 10 to set the interface's speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-
EH-GE-50P or the LC-EJ-GE-50P card. If the command
is entered for these interfaces, an error message appears.
Enter the keyword 100 to set the interface's speed to 10/100
Mb/s.
NOTE: When this setting is enabled, only 100Base-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
Enter the keyword 1000 to set the interface's speed to 1000
Mb/s. Auto-negotiation is enabled. For more information,
refer to negotiation auto.
NOTE: When this setting is enabled, only 100oBase-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
Enter the keyword auto to set the interface to auto-
negotiate its speed. Auto-negotiation is enabled. For more
information, refer to negotiation auto.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Interfaces