Speed (For 10/100/1000 Interfaces) - Dell Force10 S4810P Reference Manual

speed (for 10/100/1000 interfaces)

Set the speed for 10/100/1000 Base-T Ethernet interfaces. Both sides of a link must be set to the same speed
(10/100/1000) or to auto or the link may not come up.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed {10 | 100 | 1000} command.
Parameters
10
100
1000
auto
Defaults auto
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
This command is found on the 10/100/1000 Base-T Ethernet interfaces.
Information
When you enable auto, the system performs an automatic discovery to determine the optics
installed and configure the appropriate speed.
814
Enter the keyword 10 to set the interface's speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-EH-GE-50P
or the LC-EJ-GE-50P card. If the command is entered for these
interfaces, an error message appears.
Enter the keyword 100 to set the interface's speed to 10/100 Mb/s.
NOTE: When this setting is enabled, only 100Base-FX optics are
supported on the LC-EH-GE-50P or the LC-EJ-GE-50P card.
Enter the keyword 1000 to set the interface's speed to 1000 Mb/s.
Auto-negotiation is enabled. For more information, refer to
negotiation auto.
NOTE: When this setting is enabled, only 100oBase-FX optics are
supported on the LC-EH-GE-50P or the LC-EJ-GE-50P card.
Enter the keyword auto to set the interface to auto-negotiate its
speed. Auto-negotiation is enabled. For more information, refer to
negotiation auto.
Introduced on the Z9000.
Introduced on the S4810.
Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.