Debug Ip Igmp - Dell Z9500 Command Reference Manual

group-address
interface
interface
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command

debug ip igmp

Enable debugging of IGMP packets.
Z9500
Syntax
debug ip igmp [vrf vrf-name] [group address | interface]
•
•
806
(OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name]
[group address | interface] command.
To disable all debugging, use the undebug all command.
Internet Group Management Protocol (IGMP)