Show Ip Ospf Area - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

14.5.41 show ip ospf area

This command displays information about the area. The <
area that is being displayed.
Format
Modes
AreaID
Aging Interval
External Routing
Authentication
Type
Spf Runs
Area Border
Router Count
Area LSA Count
Area LSA
Checksum
Stub Mode
Import Summary
LSAs
Metric Value
Metric Type
14-44
show ip ospf area <areaid>
Privileged EXEC
User EXEC
Is the area id of the requested OSPF area.
Is a number representing the aging interval for this area.
Is a number representing the external routing capabilities for
this area.
Is the configured authentication type to use for this area.
Is the number of times that the intra-area route table has been
calculated using this area's link-state database.
The total number of area border routers reachable within this
area.
Total number of link-state advertisements in this area's link-
state database, excluding AS External LSAs.
A number representing the Area LSA Checksum for the spec-
ified AreaID excluding the external (LS type 5) link-state
advertisements.
Represents whether the specified Area is a stub area or not.
The possible values are enabled and disabled. This is a con-
figured value.
Controls the import of summary LSAs into stub areas. The
possible values are enabled or disabled.
Is a number representing the Metric Value for the specified
area.
Is the Default Metric Type for the specified Area. If the area
is a stub area, this field does not appear.
v4.1, October 2008
> identifies the OSPF
areaid
Routing Commands