Config Router Ospf Interface Priority; Config Router Ospf Interface Cost; Show Router Ospf Area Info - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Format

config router ospf interface priority

This command sets the OSPF priority for the specified router interface. The priority of the
interface is a priority integer from 0 to 255.
A value of '0' indicates that the router is not eligible to become the designated router on this
network.
Default
Format

config router ospf interface cost

This command configures the cost on an OSPF interface. The <ipaddr> and <slot.port> parameters
identify the interface on which to configure the cost. The <cost> parameter has a range of 1 to
65535.
Default
Format

show router ospf area info

This command displays information about the area. The <areaid> identifies the OSPF area that is
being displayed.
Format
AreaID
Aging Interval
External Routing
Spf Runs
Area Border Router Count
Area LSA Count
Area LSA Checksum
8-20
config router ospf interface mode <slot.port>
<enable|disable>
1, which is the highest router priority
config router ospf interface priority <slot.port> <0-
255>
10
config router ospf interface cost <ipaddr> <slot.port
> <1-5535>
show router ospf area info <areaid>
The area id of the requested OSPF area.
A number representing the aging interval for this area.
A number representing the external routing capabilities for this area.
The number of times that the intra-area route table has been calculated using this
area's link-state database.
The total number of area border routers reachable within this area.
Total number of link-state advertisements in this area's link-state database,
excluding AS External LSA's.
A number representing the Area LSA Checksum for the specified AreaID
excluding the external (LS type 5) link-state advertisements.
202-10009-01
Routing Commands