Show Ip Ospf Area - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
New LSAs Originated
LSAs Received
External LSDB Limit

show ip ospf area

This command displays information about the area. The <areaid> identifies the OSPF area that is
being displayed.
Format
Mode
AreaID
Aging Interval
External Routing
Authentication Type
Spf Runs
Area Border Router Count The total number of area border routers reachable within this
Area LSA Count
Area LSA Checksum
Stub Mode
Import Summary LSAs
Metric Value
Metric Type
Routing Commands
The number of new link-state advertisements that have been orig-
inated.
The number of link-state advertisements received determined to
be new instantiations.
The maximum number of non-default AS-external-LSAs entries
that can be stored in the link-state database.
show ip ospf area <areaid>
Privileged EXEC and User EXEC
Is the area id of the requested OSPF area.
Is a number representing the aging interval for this area.
Is a number representing the external routing capabilities for this
area.
Is the configured authentication type to use for this area.
Is the number of times that the intra-area route table has been cal-
culated using this area's link-state database.
area.
Total number of link-state advertisements in this area's link-state
database, excluding AS External LSA's.
A number representing the Area LSA Checksum for the specified
AreaID excluding the external (LS type 5) link-state advertise-
ments.
Represents whether the specified Area is a stub area or not. The
possible values are enabled and disabled. This is a configured
value.
Is a number representing the Metric Value for the specified area.
Is the Default Metric Type for the specified Area.
202-10009-01_060204
9-41