Set The Lacp System Priority - NETGEAR GS724TPv2 User Manual

NETGEAR 24-Port Gigabit Smart Managed Pro Switch with PoE+ and 2 SFP Ports Model GS724TPv2
The default password is password.
The System Information page displays.
5. Select Switching > LAG > Basic > LAG Membership.
6. From the LAG ID menu, select the LAG ID.
7. In the LAG Name field, enter the name to be assigned to the LAG.
You can enter any string of up to 15 alphanumeric characters. A valid name must be
specified for you to create the LAG.
8. In the Ports table, click each port that you want to include as a member of the selected
LAG.
A selected port is displayed by a check mark.
9. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.

Set the LACP System Priority

The LACP configuration page is used to set the LACP system priority.

To configure LACP:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 9.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
Change the Default IP Address of the
Configure Switching
98