Change The Language Of The Local Browser Interface - NETGEAR PROSAFE XS716E User Manual

8-Port or 16-Port 10-Gigabit/Multi-Gigabit Smart Managed Plus Switch
5. Enter the email address and password for your account and tap LOG IN.
After you log in to your account, the IP address of the switch displays in the device list.
6. Write down the IP address for future use.
7. Tap + in the upper-right corner.
8. Either use the camera on your phone to scan the serial number bar code located on the
bottom of the switch, or enter the serial number.
9. Tap Go.
10. Follow the onscreen instructions to add your switch to a network location.
The switch is registered and added to your account.
Change the language of the local browser
interface
By default, the language is set to Auto. You can set the language to a specific one.
To change the language of the local browser interface:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the switch using a web
browser on page 17.
The login window opens.
4. Enter the switch's password in the password field.
The switch's default password is password.
The Switch Information page displays.
5. At the top of the page, select a language from the language menu.
A confirmation pop-up window opens.
6. Click the OK button to confirm.
The switch restarts and you must log in again.
The language of the local browser interface is now set to the language that you selected.
Getting Started 23 User Manual