Toyota T100 1996 Service Manual page 1300

MT−20
MANUAL TRANSMISSION (R150, R150F)
SST
1996 TOYOTA T100 (RM449U)
30. REMOVE REVERSE IDLER GEAR AND SHAFT
Pull out the shaft toward the rear.
HINT:
At the time of the reassembly, please refer to the following item.
Align the reverse shift arm to the reverse idler gear shaft.
31. REMOVE OUTPUT SHAFT CENTER BEARING SNAP
RING
Using a snap ring expander, remove the snap ring.
Z03540
32. REMOVE OUTPUT SHAFT AND COUNTER GEAR
FROM INTERMEDIATE PLATE
(a) Remove the output shaft, counter gear and input shaft as
a unit from the intermediate plate by pulling on the counter
gear and tapping on the intermediate plate with a plastic
hammer.
(b) Remove the input shaft with the needle roller bearing from
the output shaft.
RM0010
33. REMOVE COUNTER REAR BEARING FROM INTER-
MEDIATE PLATE
Using SST and a hammer, remove the counter rear bearing.
SST
SST
Q07393
34. 2WD:
IF NECESSARY, REPLACE SPEEDOMETER DRIVEN
GEAR OIL SEAL
(a) Using SST, remove the oil seal.
SST
SST
25 mm
(b) Coat the lip of oil seal with MP grease.
(c) Using SST, drive in a new oil seal.
SST
Q07552
Drive in depth: 25 mm (0.98 in.)
− MANUAL TRANSMISSION ASSEMBLY
09950−60010 (09951−00620), 09950−70010
(09951−07150)
09921−00010
09201−10000 (09201−01080), 09950−70010
(09951−07150)