1996 TOYOTA T100 (RM449U)
TRANSFER
−
TRANSFER ASSEMBLY
(b)
Remove the input gear stopper, thrust bearing, race and
the 2 pins.
HINT:
At the time of installation, apply gear oil to the thrust bearing and
race.
25.
REMOVE INPUT SHAFT, THRUST BEARING AND
RACE
TF0477
26.
REMOVE PLANETARY RING GEAR
(a)
Using a screwdriver, remove the snap ring.
HINT:
At the time of installation, please refer to the following item.
Be sure the end gap of the snap ring is not aligned with the up-
per side of the case.
TF0478
(b)
Remove the plug, spring and pin.
Torque: 19 N·m (190 kgf·cm, 14 ft·lbf)
HINT:
At the time of installation, apply liquid sealer to the plug.
Sealant:
Part No.08833−00080, THREE BOND 1344,
LOCTITE 242 or equivalent
TF0479
(c)
Remove the planetary ring gear.
HINT:
At the time of installation, make sure to install the ring gear in
the correct direction.
TF0507
TR−15