Toyota T100 1996 Service Manual page 1215

ST−8
No continuity
Ohmmeter
Free
1996 TOYOTA T100 (RM449U)
STARTING (5VZ−FE)
P00303
Lock
P04514
SST
P10593
− STARTER
Minimum installed load:
1.2 kw type: 9.8 N (1.00 kgf, 2.2 lbf)
1.4 kw type: 11.8 N (1.20 kgf, 2.6 lbf)
1.8 kw type: 12.7 N (1.30 kgf, 2.7 lbf)
If the installed load is less than minimum, replace the brush
springs.
HINT:
Take the pull scale reading the instant the brush spring sepa-
rates from the brush.
11. INSPECT INSULATION OF BRUSH HOLDER
Using an ohmmeter, check that there is no continuity between
the positive (+) and negative (−) brush holders.
If there is continuity, repair or replace the brush holder.
12. INSPECT GEAR TEETH
Check the gear teeth on the pinion gear, idler gear and clutch
assembly for wear or damage.
If damaged, replace the gear or clutch assembly.
If damaged, also check the flywheel or drive plate ring gear for
wear or damage.
13. INSPECT CLUTCH
Hold the starter clutch and rotate the clutch pinion gear clock-
wise and check that it turns freely. Try to rotate the clutch pinion
counterclockwise and check that it locks. If necessary, replace
the clutch assembly.
14. INSPECT REAR BEARING
Turn the bearing by hand while applying inward force.
If the resistance is felt or if the bearing sticks, replace the bear-
ing.
15. IF NECESSARY, REPLACE REAR BEARING
(a) Using SST, remove the bearing.
SST 09286−46011