Toyota T100 1996 Service Manual page 1463

PR−16
Matchmarks
B
Matchmarks
1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT
R04437
Matchmarks
R04440
A
A
Z04758
R15508
− PROPELLER SHAFT ASSEMBLY (4WD)
INSTALLATION
1. INSTALL FRONT PROPELLER SHAFT:
(a) Align the matchmarks on the propeller shaft and differen-
tial flanges, and connect the flanges with the 4 nuts and
washers.
(b) Torque the 4 nuts.
Torque: 74 N·m (750 kgf·cm,54 ft·lbf)
(c) Align the matchmarks on the propeller shaft and transfer
flanges, and connect the flanges with the 4 bolts, washers
and nuts.
(d) Torque the 4 bolts.
Torque: 74 N·m (750 kgf·cm, 54 ft·lbf)
(e) Install the propeller shaft dust cover with the 3 bolts.
Torque:
A bolt: 36 N·m (370 kgf·cm, 27 ft·lbf)
B bolt: 23 N·m (230 kgf·cm, 17 ft·lbf)
(f) M/T:
Install the propeller shaft No.2 dust cover with the 2 bolts
and nuts.
Torque:
Bolt: 17 N·m (175 kgf·cm, 13 ft·lbf)
Nut: 13 N·m (135 kgf·cm, 10 ft·lbf)
2. INSTALL REAR PROPELLER SHAFT
(a) Align the matchmarks on the propeller shaft and transfer
flanges, and connect the flanges with 4 nuts and wash-
ers.
(b) Torque the 4 nuts.
Torque: 76 N·m (780 kgf·cm, 56 ft·lbf)
(c) Temporarily install the center support bearing with 2
mount bolts finger tight.
HINT:
Make sure the bearing is installed with facing the drain hole
downwards.
(d) Align the matchmarks on the flanges, and connect the
flanges with the 4 bolts, washers and nut.
(e) Torque the 4 bolts.
Torque: 76 N·m (780 kgf·cm, 56 ft·lbf)
PR080−01