Toyota T100 1996 Service Manual page 1722

Intermediate Shaft Assembly
Intermediate Shaft Assembly
Sliding w/ shaft York Sub−Assembly
R12250
R12251
R12252
1996 TOYOTA T100 (RM449U)
STEERING
A
Matchmarks
Sliding w/ shaft
York Sub−Assembly
B
C
Z16081
− NON−TILT STEERING COLUMN
10. DISCONNECT INTERMEDIATE SHAFT ASSEMBLY
(a) 2WD:
Place matchmarks on the intermediate shaft and control
valve shaft.
(b) 4WD:
Place matchmarks on the intermediate shaft and worm
gear valve shaft.
(c) Remove the bolt A, B and C.
11. REMOVE INTERMEDIATE SHAFT ASSEMBLY AND
SLIDING w/ SHAFT YORK SUB−ASSEMBLY
12. A/T:
REMOVE STEERING COLUMN ASSEMBLY
(a) Remove the locking wire.
(b) Remove the bolt and control shaft lever.
(c) Remove the 2 control shaft assembly mounting bolts from
the steering column assembly.
(d) Remove the 2 column assembly set bolts and nuts.
(e) Remove the steering column assembly with the control
shaft assembly.
(f) Remove the control shaft assembly from the steering col-
umn assembly.
13. M/T:
REMOVE STEERING COLUMN ASSEMBLY
Remove the 2 steering column assembly set bolts and nuts.
SR−15