Toyota T100 1996 Service Manual page 860

EM−32
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (5VZ−FE)
25.
(a)
(b)
(c)
P21245
26.
27.
Remove the 6 bolts and timing belt cover.
28.
P21193
29.
(a)
(b)
(c)
30.
31.
(a)
P21192
(b)
(c)
32.
33.
Remove the 6 nuts, crossover pipe and 2 gaskets.
34.
(a)
(b)
P21195
− CYLINDER HEAD
DISCONNECT ENGINE WIRE
Disconnect these connectors:
Oil pressure sensor connector
S
Crankshaft position sensor connector
S
6 Injector connectors
S
ECT sender gauge connector
S
ECT sensor connector
S
Knock sensor connector
S
Camshaft position sensor connector
S
Disconnect the 3 engine wire clamps.
Remove the 3 bolts, and disconnect the engine wire from
the cylinder head.
REMOVE CAMSHAFT POSITION SENSOR
REMOVE NO.3 TIMING BELT COVER
REMOVE FUEL PRESSURE REGULATOR
REMOVE INTAKE MANIFOLD ASSEMBLY
Disconnect the fuel inlet hose.
Remove the 2 bolts and the intake manifold stay.
Remove the 8 bolts, 4 nuts, 4 plate washers, intake man-
ifold, delivery pipes and injectors assembly and 2 gas-
kets.
REMOVE PS PUMP BRACKET
REMOVE OIL DIPSTICK AND GUIDE
Remove the 2 bolts holding the dipstick guide to the gen-
erator bracket.
Pull out the dipstick guide together with the dipstick from
the oil pan.
Remove the O−ring from the dipstick guide.
REMOVE GENERATOR BRACKET
REMOVE EXHAUST CROSSOVER PIPE
REMOVE LH AND RH EXHAUST MANIFOLDS
Remove the 6 nuts and exhaust manifold heat insulators.
Remove the 12 nuts, LH, RH exhaust manifolds and gas-
ket.