Toyota T100 1996 Service Manual page 1481

A
D
Front
C
Front Adjusting Cam
Decrease
Rear Adjusting Cam
Increase
FA0829
FA0828
Front
A
A = B
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
4.
B
Toe−in (total)
P235/75 R15
31 x 10.5 R15
If the toe−in is not within specification, adjust the tie rod end.
SA3213
5.
(a)
(b)
HINT:
Try to adjust the camber and caster to the center value.
(c)
Increase
Decrease
F01734
6.
(a)
R08116
(b)
HINT:
S
S
B
FA0017
− FRONT WHEEL ALIGNMENT (4WD)
INSPECT TOE−IN
A + B: 0°05' ± 12' (0.08° ± 0.2°)
0.5 ton
C − D: 1.0 ± 2 mm (0.04 ± 0.08 in.)
Extra cab A + B: −0°08' ± 12' (−0.14° ± 0.2°)
C − D: −1.9 ± 2 mm (0.07 ± 0.08 in.)
Extra cab A + B: −0°08' ± 12' (−0.14° ± 0.2°)
C − D: −2.0 ± 2 mm (0.08 ± 0.08 in.)
ADJUST CAMBER AND CASTER
Loosen the front and/or rear adjusting cam nuts.
Adjust the camber and caster by front and/or rear adjust-
ing cams (See adjustment chart).
Torque the front and/or rear adjusting cam nuts.
Torque: 226 N·m (2,300 kgf·cm, 166 ft·lbf)
ADJUST TOE−IN
Loosen the clamp bolts and nuts.
Adjust toe−in by turning the left and right tie rod tubes an
equal amount.
Try to adjust the toe−in to the center value.
Make sure that the length of the left and right tie rods end
is equal.
Author :
SA−11
Date : 1450