Toyota T100 1996 Service Manual page 1536

SA−66
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
28. INSTALL CLUTCH CASE TO SIDE GEAR SHAFT TUBE
(a) Install a new O−ring to the tube.
(b) Coat the O−ring with MP grease.
SA0371
(c) Install the clutch case to the tube.
(d) Using a torx socket (E14), torque the 2 torx bolts.
Torque: 78 N·m (800 kgf·cm, 58 ft·lbf)
29. INSTALL CLUTCH SLEEVE
SA0400
30. INSTALL LH SIDE GEAR SHAFT TO DIFFERENTIAL
CARRIER
(a) Remove any old FIPG material and be careful not to drop
oil on the contact surfaces of the differential carrier and
clutch case.
(b) Clean surfaces with FIPG material attached to using gas-
FIPG
oline or alcohol.
(c) Apply FIPG to the carrier, as shown.
FIPG:
R11760
Part No. 08826−00090, THREE BOND 1281 or equiva-
lent
HINT:
Install the side gear shaft within 10 minutes after applying FIPG.
(d) Install LH side gear shaft to the differential carrier.
(e) Using a torx socket (E14), torque the 4 torx bolts.
Torque: 78 N·m (800 kgf·cm, 58 ft·lbf)
SA0374
− FRONT DIFFERENTIAL CARRIER (4WD)