Toyota T100 1996 Service Manual page 1149

LU−12
Cut Position
1996 TOYOTA T100 (RM449U)
LUBRICATION (5VZ−FE)
P20964
SST
P20929
P20977
SST
P20965
− OIL PUMP
REPLACEMENT
REPLACE CRANKSHAFT FRONT OIL SEAL
HINT:
There are 2 methods (A and B) to replace the oil seal, which are
as follows:
(a) If oil pump is removed from cylinder block.
(1) Using a screwdriver, pry out the oil seal.
(2) Using SST and a hammer, tap in a new oil seal until
its surface is flush with the oil pump body edge.
SST 09309−37010
(3) Apply MP grease to the oil seal lip.
(b) If oil pump is installed to the cylinder block.
(1) Using a knife, cut off the oil seal lip.
(2) Using a screwdriver, pry out the oil seal.
NOTICE:
Be careful not to damage the crankshaft. Tape the screw-
driver tip.
(3) Apply MP grease to a new oil seal lip.
(4) Using SST and a hammer, tap in the oil seal until its
surface is flush with the oil pump body edge.
SST 09306−37010
LU039−03