Toyota T100 1996 Service Manual page 1612

SA−142
SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
(c)
SST
HINT:
Measure the plate washer and note down the thickness.
(d)
HINT:
Tag the bearing outer races to show the location for reassem-
R04325
bling.
10.
11.
Using SST and a press, remove the bearing from the drive pin-
ion.
HINT:
If the drive pinion or ring gear are damaged replace them as a
set.
R02482
12.
NOTICE:
Do not remove the outer races except when replacing the
bearings.
Using a brass bar and hammer, remove the 2 outer races and
adjusting washer from the carrier.
HINT:
Measure the adjusting washer and note down the thickness.
R04326
13.
(a)
(b)
(c)
Matchmarks
R04327
− REAR DIFFERENTIAL CARRIER
Using SST and a hammer, remove the 2 side bearing
plate washers.
SST 09504−22011
Remove the differential case and bearing outer race from
the carrier.
REMOVE DRIVE PINION FROM DIFFERENTIAL
CARRIER
REMOVE DRIVE PINION REAR BEARING
SST 09950−00020
REMOVE FRONT AND REAR BEARING OUTER
RACES
REMOVE RING GEAR
Place matchmarks on the ring gear and differential case.
Remove the 12 ring gear set bolts.
Using a plastic hammer, tap on the ring gear to separate
it from the differential case.