Toyota T100 1996 Service Manual page 1495

Grease
SST
SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
INSTALLATION
1. PACK BEARING WITH MP GREASE
(a) Place MP grease in the palm of your hand.
(b) Pack grease into the bearing, continuing until the grease
oozes out from the other side.
(c) Employ the same manner around the bearing circumfer-
ence.
2. COAT INSIDE OF HUB WITH MP GREASE
SA0412
3. INSTALL INNER BEARING AND OIL SEAL
(a) Place the inner bearing into the hub.
(b) Using SST and a hammer, install a new oil seal into the
hub.
SST
NOTICE:
Be careful not to damage the ABS speed sensor rotor.
(c) Coat the oil seal lip with MP grease.
R04134
4. INSTALL AXLE HUB TO STEERING KNUCKLE
(a) Place the axle hub to the steering knuckle.
NOTICE:
Be careful not to damage the ABS speed sensor rotor.
(b) Install the outer bearing.
(c) Install the claw washer.
5. ADJUST PRELOAD
(a) Using SST, torque the adjusting nut.
SST
Torque: 59 N·m (600 kgf·cm, 43 ft·lbf)
(b) Snug down the bearing by turning the hub several times.
(c) Using SST, loosen the nut until it can be turned by hand.
SST
(d) Using SST, retighten the adjusting nut.
SST
R04293
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
(e) Check that the bearing has no play.
6. INSTALL LOCK WASHER AND LOCK NUT
(a) Install a new lock washer and lock nut.
(b) Using SST, torque the lock nut.
SST
Torque: 47 N·m (480 kgf·cm, 35 ft·lbf)
− FRONT AXLE HUB (4WD)
09950−60020 (09951−00910),
09950−70010 (09951−07100)
09607−60020
09607−60020
09607−60020
09607−60020
SA−25
SA0FP−01