Toyota T100 1996 Service Manual page 1499

1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
REMOVAL
1. REMOVE BRAKE CALIPER AND FRONT AXLE HUB
(See page SA−23)
2. REMOVE DUST COVER AND OIL SEAL
R04382
3. MEASURE STEERING KNUCKLE BUSHING THRUST
CLEARANCE
(a) Install a bolt in the drive shaft.
(b) Using a feeler gauge, measure the drive shaft thrust
clearance between the steering knuckle outside bushing
and spacer, by pulling the bolt and applying a load of 98
N (10 kgf, 22.0 lbf).
Front drive shaft thrust clearance:
Standard: 0.10 − 0.50 mm (0.0039 − 0.0197 in.)
FA0781
Maximum: 1.0 mm (0.039 in.)
If the thrust clearance than the maximum, replace the steering
knuckle outside and inside bushings.
4. DISCONNECT FRONT SHOCK ABSORBER FROM
LOWER SUSPENSION ARM
Remove the nut, washer, bolt and shock absorber from the low-
er suspension arm.
R04383
5. DISCONNECT STABILIZER BAR FROM LOWER
SUSPENSION ARM
(a) Remove the nut, bolt, 5 retainers, 4 cushions and collar.
(b) Disconnect the stabilizer bar from the lower suspension
arm.
R04384
− STEERING KNUCKLE (4WD)
SA−29
SA0FS−01