Toyota T100 1996 Service Manual page 1459

PR−12
Matchmarks
Matchmarks
Matchmarks
1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT −
DISASSEMBLY
1. Front:
REMOVE SLEEVE YOKE FROM FRONT PROPELLER
SHAFT
(a) Place matchmarks on the sleeve yoke and propeller
shaft.
(b) Pull out the sleeve yoke from the propeller shaft.
R04444
2. Rear:
SEPARATE PROPELLER SHAFT AND INTERMEDI-
ATE SHAFT
(a) Place the matchmarks on the flanges.
(b) Remove the 4 nuts, bolts and washers.
R04445
3. REMOVE CENTER SUPPORT BEARING FROM IN-
TERMEDIATE SHAFT
(a) Using a hammer and chisel, loosen the staked part of the
nut.
(b) Using SST to hold the flange, remove the nut.
SST
(c) Place matchmarks on the flange and shaft.
SST
Z04243
(d) Using SST, remove the flange from the intermediate
shaft.
SST
SST
(e) Remove the center support bearing from the intermediate
shaft.
Q06613
PROPELLER SHAFT ASSEMBLY (4WD)
09330−00021
09950−30010
PR01O−02