Toyota T100 1996 Service Manual page 1076

SST
Ohmmeter
1996 TOYOTA T100 (RM449U)
SFI (5VZ−FE)
INSPECTION
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Using SST, remove the knock sensor.
Knock Sensor 1
Knock Sensor 2
P21182
11.
Using an ohmmeter, check that there is no continuity between
the terminal and body.
If there is continuity, replace the sensor.
12.
Using SST, install the knock sensor.
13.
P01630
14.
15.
16.
17.
18.
− KNOCK SENSOR
DRAIN ENGINE COOLANT
REMOVE AIR CLEANER HOSE
REMOVE INTAKE AIR CONNECTOR (See page
EM−30)
REMOVE HIGH−TENSION CORDS WITH IGNITION
COILS (See page IG−7)
REMOVE TIMING BELT AND CAMSHAFT TIMING
PULLEYS (See page EM−13)
REMOVE TIMING BELT IDLER NO. 2
REMOVE FUEL PRESSURE REGULATOR (See page
SF−16)
REMOVE INTAKE MANIFOLD ASSEMBLY (See page
EM−30)
REMOVE WATER BYPASS PIPE AND KNOCK SEN-
SOR WIRE (See page EM−84)
REMOVE KNOCK SENSORS
SST 09816−30010
INSPECT KNOCK SENSORS
INSTALL KNOCK SENSORS
SST 09816−30010
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
INSTALL WATER BYPASS PIPE AND KNOCK SEN-
SOR WIRE (See page CO−5)
INSTALL INTAKE MANIFOLD ASSEMBLY (See page
EM−51)
INSTALL FUEL PRESSURE REGULATOR (See page
SF−17)
INSTALL TIMING BELT IDLER NO. 2 (See page
EM−19)
INSTALL CAMSHAFT TIMING PULLEYS AND TIMING
BELT (See page EM−19)
INSTALL HIGH−TENSION CORDS WITH IGNITION
COILS (See page IG−8)
SF−57
SF0CV−04