Torque Converter Clutch And Drive Plate Inspection - Toyota T100 1996 Service Manual

AT−38
SST
Hold
Turn
1996 TOYOTA T100 (RM449U)
AUTOMATIC TRANSMISSION
TORQUE CONVERTER CLUTCH
AND DRIVE PLATE
INSPECTION
1.
(a)
(b)
AT0953
(c)
If necessary, clean the converter and retest the clutch.
(d)
Lock
Free
AT3306
2.
Set up a dial indicator, measure the drive plate runout.
If runout is not within the specification or if the ring gear is dam-
aged, replace the drive plate.
D00843
− TORQUE CONVERTER CLUTCH AND DRIVE PLATE
INSPECT ONE−WAY CLUTCH
Install SST in the inner race of one−way clutch.
SST 09350−30020 (09351−32010)
Install SST so that it fits in the notch of the converter hub
and outer race of the one−way clutch.
SST 09350−30020 (09351−32020)
With the torque converter clutch standing on its side,
check that the clutch locks when turned counterclock-
wise, and rotates freely and smoothly clockwise.
Replace the converter if the clutch still fails the test.
MEASURE DRIVE PLATE RUNOUT AND INSPECT
RING GEAR
Maximum runout: 0.20 mm (0.0079 in.)
Torque: 83 N·m (850 kgf·cm, 61 ft·lbf)
Author :
AT02G−06
1379
Date :