Toyota T100 1996 Service Manual page 1617

SST
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE
HINT:
First fit a washer with the same thickness as the washer which
was removed, then after checking the tooth contact pattern, re-
place the washer with one of a different thickness if necessary.
6.
Using SST and a press, install the rear bearing onto the drive
pinion.
SST
R00055
7.
(a)
HINT:
Assemble the spacer, washers and oil seal after adjusting the
gear contact pattern.
(b)
SST
R11163
(c)
(d)
NOTICE:
As there is no spacer, tighten the nut a little at a time, being
careful not to overtighten it.
SA2351
(e)
SA2446
− REAR DIFFERENTIAL CARRIER
INSTALL DRIVE PINION REAR BEARING
SST 09506−35010
TEMPORARILY ADJUST DRIVE PINION PRELOAD
Install the drive pinion and front bearing.
Using SST, install the companion flange.
SST 09950−30010
Coat the threads of the nut with hypoid gear oil.
Adjust the drive pinion preload by tightening the compan-
ion flange nut.
Using SST to hold the flange, torque the nut.
SST 09330−00021
Using a torque wrench, measure the preload.
Preload (at starting):
New bearing:
1.0 − 1.6 N·m (10 − 16 kgf·cm, 8.7 − 13.9 in.·lbf)
Reused bearing:
0.5 − 0.8 N·m (5 − 8 kgf·cm, 4.3 − 6.9 in.·lbf)
SA−147