Toyota T100 1996 Service Manual page 1442

TR−34
SST
1996 TOYOTA T100 (RM449U)
TF0493
TF0494
SST
TF0496
SST
Q06505
TF0498
TRANSFER − PLANETARY GEAR
INSPECTION
1. INSPECT PINION GEAR THRUST CLEARANCE
Using a feeler gauge, measure the planetary pinion gear thrust
clearance.
Standard clearance:
0.11 − 0.86 mm (0.0043 − 0.0339 in.)
Maximum clearance: 0.86 mm (0.0339 in.)
If the clearance exceeds the maximum, replace the planetary
gear assembly
2. INSPECT PLANETARY PINION GEAR RADIAL
CLEARANCE
Using a dial indicator, measure the radial clearance of the plan-
etary pinion gear.
Standard clearance:
0.009 − 0.038 mm (0.0004 − 0.0015 in.)
Maximum clearance: 0.038 mm (0.0015 in.)
If the clearance exceeds the maximum, replace the planetary
gear assembly.
3. IF NECESSARY, REPLACE PLANETARY GEAR OUT-
ER BEARING
(a) Using a snap ring expander, remove the snap ring.
(b) Using SST and a press, remove the outer bearing.
SST 09554−30011, 09555−55010
(c) Using SST and a press, install a new bearing with the out-
er race snap ring groove the front.
SST 09223−15020, 09515−30010, 09550−22011
(09550−00020)
(d) Select a snap ring that will allow minimum axial play.
Mark
1
2
3
4
5
(e) Using a snap ring expander, install the snap ring.
Thickness mm (in.)
1.45 − 1.50 (0.0571 − 0.0591)
1.50 − 1.55 (0.0591 − 0.0610)
1.55 − 1.60 (0.0610 − 0.0630)
1.60 − 1.65 (0.0630 − 0.0650)
1.65 − 1.70 (0.0650 − 0.0669)
TR028−02