Toyota T100 1996 Service Manual page 1771

SR−64
SST
SST
Oil Seal
Vinyl Tape
Rack Teeth End
SST
1996 TOYOTA T100 (RM449U)
STEERING
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1. COAT WITH POWER STEERING FLUID OR MOLYBDE-
NUM DISULFIDE LITHIUM BASE GREASE (See page
SR−54)
2. INSTALL OIL SEAL
(a) Coat a new oil seal lip with power steering fluid.
(b) Using SST, press in the oil seal.
SST
NOTICE:
Make sure to install the oil seal facing the correct
S
direction.
Take care that the oil seal does not get reversed as
SST
S
F00854
you install it.
3. INSTALL STEERING RACK
HINT:
If necessary, scrape the burrs off the rack teeth end then clean
and burnish before installation.
(a) Make sure that the tube hole is not clogged with grease.
HINT:
If the tube hole is clogged, the pressure inside the boot will
change after it is assembled and the steering wheel turned.
(b) Install SST to the rack.
SST
(c) Coat SST with power steering fluid.
(d) Insert the rack into the rack housing.
NOTICE:
Be careful not to damage the oil seal lip.
(e) Remove the SST.
W03126
− POWER STEERING GEAR (2WD)
09950−60010 (09951−00240, 09951−00430,
09952−06010), 09950−70010 (09951−07360)
09631−33010
SR07Y−01