Front Wheel Alignment (4Wd) - Toyota T100 1996 Service Manual

SA−10
Front
B
Rear
C
FA0442
R12257
1996 TOYOTA T100 (RM449U)
SUSPENSION AND AXLE

FRONT WHEEL ALIGNMENT (4WD)

INSPECTION
HINT:
For the vehicle height of non−loaded vehicles for each model
and alignment standed values, refer to page SA−121.
A
1. MEASURE VEHICLE HEIGHT
Vehicle height:
Front: A − B = 58.0 mm (2.283 in.)
Rear: C − B = STD cab: 23.0 mm (0.906 in.)
Measuring points:
A: Drive shaft height measured at its center on the
outer edge.
B: Lower suspension arm front adjusting bolt height
D
measured at its center.
C: Rear leaf spring front bushing height measured at
its center.
D: Rear axle shaft height measured at its center.
F01732
NOTICE:
Before inspecting the wheel alignment, adjust the vehicle
height to specification.
If the vehicle height is not standard, try to adjust it by pushing
down on or lifting the body.
2. INSTALL CAMBER−CASTER−KINGPIN GAUGE OR
ONTO WHEEL ALIGNMENT TESTER
Follow the specific instructions of the equipment manufacturer.
3. INSPECT CAMBER, CASTER AND STEERING AXIS
Z03382
INCLINATION
STD cab
Camber
Caster
Steering axis inclination
Extra cab
Camber
Caster
Steering axis inclination
If the steering axis inclination is not as specified, after camber
and caster have correctly adjusted, recheck the steering
knuckle front wheel for bearing or looseness.
− FRONT WHEEL ALIGNMENT (4WD)
Extra cab: 28.0 mm (1.102 in.)
Left−right error
Left−right error
Left−right error
Left−right error
Left−right error
Left−right error
Author :
SA0FG−02
0°45' ± 45' (0.75° ± 0.75°)
45' (0.75°) or less
1°30' ± 45' (1.5° ± 0.75°)
45' (0.75°) or less
11°50' ± 45' (11.83° ± 0.75°)
45' (0.75°) or less
0°45' ± 45' (0.75° ± 0.75°)
45' (0.75°) or less
1°20' ± 45' (1.33° ± 0.75°)
45' (0.75°) or less
11°50' ± 45' (11.83° ± 0.75°)
45' (0.75°) or less
Date :
1449