Toyota T100 1996 Service Manual page 1432

TR−24
SST
1996 TOYOTA T100 (RM449U)
TRANSFER − REAR OUTPUT SHAFT
DISASSEMBLY
1. INSPECT DRIVE SPROCKET THRUST CLEARANCE
Using a feeler gauge, measure the drive sprocket thrust clear-
ance.
Standard clearance:
0.10 − 0.25 mm (0.0039 − 0.0098 in.)
Maximum clearance: 0.25 mm (0.0098 in.)
If the clearance exceeds the maximum, replace the drive
sprocket.
TF0516
2. M/T:
REMOVE HIGH AND LOW HUB SLEEVE
ASSEMBLY
(a) Using a snap ring expander, remove the snap ring.
(b) Remove the hub sleeve and 3 shifting keys.
(c) Using a press, remove the clutch hub, 2 key springs and
key retainer.
TF0517
3. A/T:
REMOVE HIGH AND LOW HUB SLEEVE
ASSEMBLY
(a) Using a snap ring expander, remove the snap ring.
(b) Remove the hub sleeve.
(c) Using a press, remove the clutch hub.
TF0549
4. REMOVE REAR BEARING, SPACER AND DRIVE
SPROCKET WITH FRONT DRIVE CLUTCH SLEEVE
ASSEMBLY
(a) Using SST and a press, remove the bearing.
SST
TF0518
(b) Remove these parts:
Spacer and ball
S
Drive sprocket with front drive hub and hub sleeve
S
Needle roller bearing
S
Synchronizer ring
S
TF0620
09950−00020
TR0D3−01